Step 1. The white cross
How to build the white cross: placing edges, fixing flipped or stuck pieces, and checking the result without breaking what you have already solved.
Goal: four white edges around the white centre, with each edge’s side colour matching the centre of that face.
The diagram shows the white layer on top. Hold the cube with white down — it makes the next step easier, and you can always flip the cube to check the result.
Why the cross comes first
The cross is the skeleton of the first layer. It locks the four side centres into position; later you just fill the gaps between them with corners. If the cross is wrong — white edges present but side colours mismatched — the first layer can never be completed.
The rule for this step: the side sticker of every white edge must match the centre of that face. White itself only goes up or down.
Before you start
- Find the white centre and turn the cube so white faces down.
- Locate all four edges with a white sticker. An edge has two stickers, so it always has a white one and one more colour.
- Do not worry about breaking pieces that are not placed yet.
The daisy method
If this is your first solve, start with a “daisy”: four white edges around the yellow centre on top.
- Put all four white edges around the yellow centre with the white stickers facing up. You get a yellow middle and four white petals.
- Take one edge. Turn the top layer (U) until its side colour matches the centre below it.
- Turn that side face 180° — the edge drops down and joins the white cross, white facing down.
- Repeat for the other three edges.
Now flip the cube: the white cross is on the bottom, and all four side colours match their centres.
When an edge will not go in
Every situation is one of four:
| Where the edge is | What it looks like | What to do |
|---|---|---|
| Top layer, white up | a daisy petal | Match the side colour with its centre, turn the face 180° |
| Top layer, white sideways | white sticker on a side face | Turn the face so the edge goes to the middle layer, then bring it back up white-up |
| Middle layer | white sticking out sideways | One face turn brings it to the top layer |
| Bottom layer, wrong slot or flipped | white not down, or under the wrong centre | Turn the face 180°, bring the edge up and place it again |
If the edge you need is blocked by an already placed one, turn the top layer first — that almost always frees a slot without breaking the cross.
Check
- Bottom face: a white cross around the white centre.
- On every side face, the edge sticker matches the centre.
- No “skewed” cross: no white edge sitting between centres of different colours.
Common mistakes
- White cross without matching side colours. The most common one: white stickers are in place but the sides are swapped.
- Turning the whole cube instead of faces. U and side turns are enough; re-gripping only confuses you.
- Trying to preserve everything at once. Nothing is solved yet — it is fine to disturb the daisy temporarily.
Mini FAQ
How long does the first cross take? Five to ten minutes at first, then under a minute.
Can I build the cross on top instead? Yes, but the next steps are easier with the solved layer down.
What if I only see three white edges? The fourth is flipped or hidden in the middle layer. Look for the edge with a white sticker.