Step 5. Last layer edges
Permuting the yellow edges so their side colours match the centres. One formula, repeated with U adjustments.
Goal: the yellow cross is aligned — each of its edges matches the centre of the face it sits on. Corners can be anywhere.
What “aligned” means
After step 4 you have a yellow cross, but its edges may point at the wrong centres: an edge with a green side sticker sitting above the red centre, for example.
Aligned means every edge’s side sticker matches the centre of that face. When all four match, the step is done.
The formula
R U R' U R U2 R'
This is Sune, one of the most useful formulas in cubing. It keeps the edge at the front and cycles the other three edges. It also twists corners — that is expected, corners are handled in steps 6 and 7.
How to apply
- Find an edge that is already aligned.
- Hold it at the front, facing you.
- Apply the formula. The other three edges cycle.
- Check the result. If not all four match, turn U, put the aligned edge at the front again and repeat.
Usually one or two applications are enough. You never stay without an aligned edge for more than one application.
If no edge is aligned
Apply the formula once from any position. One edge will align — then follow the steps above.
Check
- Yellow cross on top.
- The four edge side stickers match their centres.
- The two bottom layers are still solved.
- Corners may be twisted — that is the next step.
Common mistakes
- Holding the aligned edge at the back. Sune preserves the edge at the front (F), not the back.
- Rotating the cube. Turn only the top layer.
- Stopping with two edges aligned. You need all four; keep adjusting U.
- Confusing edges and corners. Edges first, corners later.
Mini FAQ
Why does the formula twist corners? That is how Sune works: it cycles edges and twists corners at the same time. For a beginner solve that is convenient, since corners are solved later anyway.
Is there another formula? There are alternatives, but Sune is the shortest and you will need it in CFOP too.
Everything broke after the formula. You probably turned R instead of R', or the wrong face. Reset the yellow-up orientation and start the step again.
Diagrams
Move by move: